DFRobotUPS 0.4.8

DFRobotUPS module

DFROBOTUPS MODULE

It supports the DFRobotUPS HAT for the Raspberry Pi Zero (the more sophisticated version for other Pis has not be checked nor tested) and can retrieve information about the HAT itself, as well as dynamic data for the current SoC (State of Charge) and cell voltage.

In addition, it can be run in a mode to poll the SoC and trigger a shutdown command when it falls below a specified level.

This module contains can be used as a standalone utility or imported for use in other scripts.

The module was developed and used under Python 3.9 on Raspberry PiOS 11.9.

The information to write the module was taken from the DFRobotUPS wiki at: https://wiki.dfrobot.com/UPS%20HAT%20for%20Raspberry%20Pi%20%20Zero%20%20SKU%3A%20DFR0528

Command line options

The command line options listed with --help are shown below:

usage: DFRobotUPS [-h] [-s] [-p PERCENT] [-i INTERVAL] [-c CMD [ARG ...]]
                  [-a ADDR] [-b BUS] [-r RETRY] [-d] [-v]

optional arguments:
  -h, --help            show this help message and exit
  -s, --shutdown        poll the battery SoC and initiate system shutdown when
                        level drops below the defined level; the default is
                        not to do this but display information about the UPS
                        HAT instead
  -p PERCENT, --percent PERCENT
                        State of Charge (SoC) percentage at which to trigger
                        shutdown shutdown (min: 5, max: 95, default: 7)
  -i INTERVAL, --interval INTERVAL
                        number of seconds between polls of the battery SoC
                        (min: 1, max: 600, default: 60)
  -c CMD [ARG ...], --cmd CMD [ARG ...]
                        command to run to trigger shutdown
  -a ADDR, --addr ADDR  I2C address for UPS HAT; can be specified in hex as
                        0xNN (default: 0x10)
  -b BUS, --bus BUS     I2C SMBus number for UPS HAT (default: 1)
  -r RETRY, --retry RETRY
                        number of times to try connecting to the UPS HAT
                        (default: 10)
  -d, --debug           increase debugging level (max: 2, default: 0)
  -v, --version         show program's version number and exit

Author

Robert Franklin [e-mail], UK