airbyte-source-adjust 0.1.0

Source implementation for Adjust.

Adjust Source

This is the repository for the Adjust source connector, written in Python. For information about how to use this connector within Airbyte, see the documentation.

To iterate on this connector, make sure to complete this prerequisites section.

From this connector directory, create a virtual environment:

python -m venv .venv

This will generate a virtualenv for this module in .venv/. Make sure this venv is active in your development environment of choice. To activate it from the terminal, run:

source .venv/bin/activate
pip install -r requirements.txt
pip install '.[tests]'

If you are in an IDE, follow your IDE's instructions to activate the virtualenv.

Note that while we are installing dependencies from requirements.txt, you should only edit setup.py for your dependencies. requirements.txt is used for editable installs (pip install -e) to pull in Python dependencies from the monorepo and will call setup.py. If this is mumbo jumbo to you, don't worry about it, just put your deps in setup.py but install using pip install -r requirements.txt and everything should work as you expect.

If you are a community contributor, follow the instructions in the documentation to generate the necessary credentials. Then create a file secrets/config.json conforming to the source_adjust/spec.yaml file. Note that any directory named secrets is gitignored across the entire Airbyte repo, so there is no danger of accidentally checking in sensitive information. See integration_tests/sample_config.json for a sample config file.

If you are an Airbyte core member, copy the credentials in Lastpass under the secret name source adjust test creds and place them into secrets/config.json.

python main.py spec
python main.py check --config secrets/config.json
python main.py discover --config secrets/config.json
python main.py read --config secrets/config.json --catalog integration_tests/configured_catalog.json

Via airbyte-ci (recommended):

airbyte-ci connectors --name source-adjust build

An image will be built with the tag airbyte/source-adjust:dev.

Via docker build:

docker build -t airbyte/source-adjust:dev .

Then run any of the connector commands as follows:

docker run --rm airbyte/source-adjust:dev spec
docker run --rm -v $(pwd)/secrets:/secrets airbyte/source-adjust:dev check --config /secrets/config.json
docker run --rm -v $(pwd)/secrets:/secrets airbyte/source-adjust:dev discover --config /secrets/config.json
docker run --rm -v $(pwd)/secrets:/secrets -v $(pwd)/integration_tests:/integration_tests airbyte/source-adjust:dev read --config /secrets/config.json --catalog /integration_tests/configured_catalog.json

You can run our full test suite locally using airbyte-ci:

airbyte-ci connectors --name=source-adjust test

Customize acceptance-test-config.yml file to configure tests. See Connector Acceptance Tests for more information. If your connector requires to create or destroy resources for use during acceptance tests create fixtures for it and place them inside integration_tests/acceptance.py.

All of your dependencies should go in setup.py, NOT requirements.txt. The requirements file is only used to connect internal Airbyte dependencies in the monorepo for local development. We split dependencies between two groups, dependencies that are:

• required for your connector to work need to go to MAIN_REQUIREMENTS list.
• required for the testing need to go to TEST_REQUIREMENTS list