bme680 1.1.0

Python library for the BME680 temperature, humidity and gas sensor

BME680

https://shop.pimoroni.com/products/bme680

The state-of-the-art BME680 breakout lets you measure temperature, pressure, humidity, and indoor air quality.

Installing

Full install (recommended):

We've created an easy installation script that will install all pre-requisites and get your BME680 up and running with minimal efforts. To run it, fire up Terminal which you'll find in Menu -> Accessories -> Terminal on your Raspberry Pi desktop, as illustrated below:

In the new terminal window type the command exactly as it appears below (check for typos) and follow the on-screen instructions:

curl https://get.pimoroni.com/bme680 | bash

Manual install:

Library install for Python 3:

sudo pip3 install bme680

Library install for Python 2:

sudo pip2 install bme680

Development:

If you want to contribute, or like living on the edge of your seat by having the latest code, you should clone this repository, cd to the library directory, and run:

sudo python3 setup.py install

(or sudo python setup.py install whichever your primary Python environment may be)

In all cases you will have to enable the i2c bus.

Documentation & Support

• Guides and tutorials - https://learn.pimoroni.com/bme680-breakout
• Get help - http://forums.pimoroni.com/c/support

Changelog

1.1.0

• New: support for BME688 "high" gas resistance variant
• New: set/get gas heater disable bit
• Enhancement: fail with descriptive RuntimeError when chip is not detected

1.0.5

• New: set_temp_offset to calibrate temperature offset in degrees C

1.0.4

• Fix to range_sw_err for extremely high gas readings
• Convert to unsigned int to fix negative gas readings

1.0.3

• Merged temperature compensation fix from Bosch's BME680_driver 3.5.3

1.0.2

• Fixed set_gas_heater_temperature to avoid i2c TypeError

1.0.1

• Added Manifest to Python package

1.0.0

• Initial release