grib2io-interp 1.0.2

Interpolation component for grib2io providing a Python interface to NCEPLIBS-ip

grib2io-interp: Spatial Interpolation component for grib2io

Introduction

grib2io-interp is the spatial interpolation component for grib2io. This package provides a Python interface to the NCEPLIBS-ip Fortran Library and contains a single NumPy/F2PY extension module. Originally, it was a part of the grib2io package, but since it requires NumPy's distutil's Extension and setup to build and install, it needs to be handled separately from the other grib2io source that are using setuptools. This package contains an extension module, interpolate, that provides interfaces to Fortran subroutines and these subroutines serve as wrappers to NCEPLIBS-ip subroutines. The following table illustrates the mapping:

grib2io-interp	NCEPLIBS-ip
interpolate.interpolate_scalar	ipolates_grib2
interpolate.interpolate_vector	ipolatev_grib2

NOTE: It is recommended that you use grib2io.interpolate function to access the interpolation subroutines provided by grib2io-interp.

Documentation

NOAA-MDL/grib2io-interp

Required Software

Despite this package being a component for grib2io, grib2io is not a formal dependency for grib2io-interp.

• Python 3.8+
• NCEPLIBS-sp 2.4.0+
• NCEPLIBS-ip 4.1.0+
• setuptools 61.0+
• NumPy 1.22+
• Fortran Compiler: GNU (gfortran) and Intel (ifort) been tested.

NCEPLIBS Libraries

sp and ip

The NCEP Spectral Interpolation (NCEPLIBS-sp) library is a dependency for the NCEP Interpolation (NCEPLIBS-ip) library. Both of these libraries are Fortran-based and contains OpenMP directives.

Installation

If NCEPLIBS-sp, and NCEPLIBS-ip libraries have been installed to custom locations (i.e. not default paths), then define the root of these installations via environment variables SP_DIR, and IP_DIR, respectively.

pip install grib2io-interp

Build and Install from Source

• Clone GitHub repository or download a source release from GitHub or PyPI.

• Edit setup.cfg to define the sp, and ip library installation paths OR define SP_DIR and IP_DIR environment variables.

• Build and install. Use --user to install into personal space ($HOME/.local).

pip install .

To build with Intel compilers, perform the following

pip install . --config-settings="--build-option=build --fcompiler=intelem"

Disclaimer

This repository is a scientific product and is not official communication of the National Oceanic and Atmospheric Administration, or the United States Department of Commerce. All NOAA GitHub project code is provided on an 'as is' basis and the user assumes responsibility for its use. Any claims against the Department of Commerce or Department of Commerce bureaus stemming from the use of this GitHub project will be governed by all applicable Federal law. Any reference to specific commercial products, processes, or services by service mark, trademark, manufacturer, or otherwise, does not constitute or imply their endorsement, recommendation or favoring by the Department of Commerce. The Department of Commerce seal and logo, or the seal and logo of a DOC bureau, shall not be used in any manner to imply endorsement of any commercial product or activity by DOC or the United States Government.