pythonRSC 0.2.0

An emulator for the RSC architecture written in Python.

pythonRSC ( Relatively Simple Computer in Python )

pythonRSC is an emulator for the RSC architecture written in Python.

With this program, you can generate bytecode from microcode files for Logisim or just emulate microcode files out right. Additionally, you can debug your program and see its every step.

Installing pythonRSC

To download the package, you can simply use pip.

pip install pythonRSC

Emulating your microcode using pythonRSC

After downloading the package, you should have access to a command called 'pythonRSC'. To use this command, you will need a microcode file to emulate. There are some test files provided.

pythonRSC run microcode.txt

This will parse the given microcode and output the state at the end of emulation.

Generating bytecode using pythonRSC

If you desire to use the in-built assembler to parse the microcode into logisim bytecode, there is a command for that. You will need to provide a microcode input file and it requires an output file to function.

pythonRSC assembler microcode.txt output.txt

Using pythonRSC as a library

To use this package as a library, you can simply import the classes that you wish to use in your own python code. To learn more about those classes, you will need to read the source code.

This example shows some in-built functions inside of pythonRSC that you could use.

from pythonRSC import pyRSC


pyRSC = pyRSC.RSC("..\\tests\\avg.txt")
pyRSC.run() # Runs the given instructions and gives you an output!
pyRSC.assembler.logisim_format("output.txt") # Logisim-formatted binary output
pyRSC.debugger.disas_rang(0x0, 0x17) # Disassemble a range of instructions

Emulating and debugging your microcode using pythonRSC

If you want to debug your program, pythonRSC provides an easy-to-use debugger similar to GDB Debugger. To start the emulator with the debugger, use this command. This portion of the emulator is subject to change and may produce bugs, but it is usable and useful!

pythonRSC debug microcode.txt

After executing, you will be met with a blinking >> awaiting your next command. The list of commands accepted by the debugger are listed below.

stepi [stepsize] This will 'step' forward once if stepsize is not provided, otherwise it will step as many times as provided in stepsize

bp [addr|label] This will set a breakpoint at the given address in hex or decimal or at a given label. Breakpoints are enabled on initialization.

enable [addr|label] This will turn on a breakpoint if it was disabled.

disable [addr|label] This will turn off a breakpoint.

disas [start] [end] This will take a range of addresses and disassemble the instructions. Hexadecimal or decimal.

disas This variation of the disassemble command will try to identify if you are inside a label and disassemble that label for you. This is under construction and may produce bugs.

print [type] [reg] This will print a register in your desired format (type). The types are /d (decimal) /t (binary) /x (hexadecimal)

run Resumes emulation unless a breakpoint is hit or HALT is met.

info This will print the current state of the emulator, in other words print all registers.

help This will just list the possible commands.