sartorius 0.1.1

Python driver for Sartorius and Minebea Intec scales.

sartorius

Asynchronous python ethernet interface and command-line tool for Sartorius and Minebea Intec scales.

Compatibility

This driver should work for any ethernet scale that uses the standardized communications protocol of the Scale Manufacturers Association. However, it has only been tested on the following models:

• Minebea Intec Signum
• Sartorius Entris
• Sartorius Miras

Installation

pip install sartorius

Scale Setup

For scale setup, navigate to SETUP - UNICOM - DATAPROT - ETHER.

• Make sure SRC.IP is set to a valid LAN address
• Ensure MODE - SBI-SRV - 6.1.1 is set (manual says this should be default but it is not)
• All other defaults are good

This driver is intended to be stable to disconnects, so operators should be able to unplug and reposition the device without affecting any long polling.

Command Line

$ sartorius scale-ip.local
{
    "mass": 0.0,
    "units": "kg",
    "stable": true,
    "info": {
        "model": "SIWADCP-1-",
        "serial": "37454321",
        "software": "00-37-09"
    }
}

You can tare and zero with --zero and remove the info field with --no-info. See sartorius --help for more.

To use in shell scripts, parse the json output with something like jq. For example, sartorius scale-ip.local | jq .mass will return the mass.

Python

If you'd like to link this to more complex behavior, consider using a Python script. This driver exclusively supports asynchronous Python ≥3.7.

import asyncio
import sartorius

async def get():
    async with sartorius.Scale('scale-ip.local') as scale:
        await scale.zero()             # Zero and tare the scale
        print(await scale.get())       # Get mass, units, stability
        print(await scale.get_info())  # Get model, serial, software version

asyncio.run(get())