flasfka

Push/Pull on Kafka over HTTP

Installation

You can install kafka with pip:

pip install kafka

Alternatively, you can build and use the debian package.

Configuration

To set up flasfka to talk to the Kafka cluster, the following variables are available. Put this in a file (for example /etc/flasfka.conf.py):

# Hosts in the kafka cluster (list of ip:port)
HOSTS=["localhost:9092"]

# You probably don't need to change these

# How long to wait when polling a topic for new messages
CONSUMER_TIMEOUT=0.1

# Maximum of messages returned when consuming from a topic
CONSUMER_LIMIT=100

# When you don't specify a group for listening to a topic, flasfka
# will use this one
DEFAULT_GROUP="flasfka"

The file will be read at flasfka startup, provided it is in the environment variable FLASFKA_CONFIG:

export FLASFKA_CONFIG=/etc/flasfka.conf.py

Running flasfka is then just a matter of launching:

flasfka-serve

By default, it runs on the port 5000. Use flasfka-serve -h to learn how to change that. The debian package wraps flasfka into a uwsgi service, so you don’t need to worry about this if you are using it.

Usage

Now, assuming flasfka is configured and running:

curl -X POST --data-binary '{"messages": ["msg1", "msg2"]}' "http://127.0.0.1:5000/my-topic/"

curl -X POST --data-binary '{"messages": ["msg3"]}' "http://127.0.0.1:5000/my-topic/my-key/"

curl http://127.0.0.1:5000/my-topic/

curl http://127.0.0.1:5000/my-topic/my-group/

curl http://127.0.0.1:5000/my-topic/?limit=20

Limitations

Flafska only accepts json data, so your messages need to be in utf-8. If you want to pass arbitrary data, it is recommended to encode them to a suitable format before (e.g. base64).