AppleTun 0.0.4

A utility for creating and connecting to a local VPN for ios devices allowing HTTP proxy without device supervision for all connections (not limited to Wi-Fi)

AppleTun

Description

A utility for creating and connecting to a local VPN for iOS devices allowing HTTP proxy without device supervision for all connections (not limited to Wi-Fi)

Requirements

StrongSwan installation is required. Installation of StrongSwan can be done via brew install strongswan, any other package manager, or a manual build (incase special flags are required, exporting of session keys to files for example).

Installation

python3 -m pip install -U AppleTun

Usage

Usage: appletun [OPTIONS] COMMAND [ARGS]...

Options:
  --help  Show this message and exit.

Commands:
  install-profile  Install AppleTun VPN profile (override if already exists)
  remove-profile   Remove AppleTun VPN profile
  start            Start AppleTun VPN
  stop             Stop AppleTun VPN

Example

In this example, a VPN profile is installed together with Proxyman certificate for use with the http proxy.

1. Install a profile with Proxyman certificate:

   ➜  appletun git:(master) ✗ appletun install-profile -C proxyman-ca.pem
   Profile installed, please accept installation on device
   Please allow installed certificate under Settings > General > About > Certificate Trust Settings
   

2. Accept the new profile on the iOS device.

3. Allow the installed certificate under Settings > General > About > Certificate Trust Settings

4. Start the VPN server:

   ➜  appletun git:(master) ✗ appletun start
   installed profile: AppleTunVPN PSK ************ HTTP 192.168.1.2:9090
   VPN Running
   Please activate VPN connection on Client device
   

5. Connect to the VPN from the device.

Inner implementation details

The generated ipsec.conf configuration from the Example would look as follows:

conn AppleTun
  left=0.0.0.0                  # Server listens on any IPv4 address
  leftid=AppleTun               # Identity presented by the server
  leftsubnet=0.0.0.0/0,::/0     # Server-side networks (IPv4 and IPv6)
  leftauth=psk                  # Server uses a pre-shared key

  right=%any                    # Accept any client IP
  rightid=%any                  # Accept any client identity
  rightdns=%config4,%config6    # Push DNS settings (IPv4, IPv6)
  rightsubnet=%dynamic          # Dynamically assign subnets to clients
  rightsourceip=133.33.37.0/24,fec3:1337::0/112   # IPv4/IPv6 pool for clients
  rightauth=psk                 # Client also uses a pre-shared key

  ike=aes256-sha256-ecp256,aes256-sha256-modp2048!     # Phase 1 proposals
  esp=aes256-sha256-ecp256,aes256-sha256-modp2048!     # Phase 2 proposals
  keyexchange=ikev2             # Use IKEv2 protocol
  auto=add                      # Load connection at startup

While the following line would be added to ipsec.secrets:

AppleTun : PSK "************"