adbuart

Open an Android-device UART in a local miniterm session over adb, or expose it as a local PTY for tools such as minicom, picocom, and pyserial.

This is useful when a device has no host-side USB serial adapter and its console is reachable only through an Android UART device.

Requirements

• Linux or another POSIX-like host with Python 3.10+
• adb installed and available in PATH
• An adb-connected Android device where adb root is allowed
• Target-side UART device access, defaulting to /dev/ttyHS1

Install

python3 -m pip install adbuart

Usage

Open the UART directly in miniterm:

adbuart

With multiple adb devices attached, pass the adb serial explicitly:

adbuart -s SERIAL

Press Ctrl+] to exit, or Ctrl+T followed by Ctrl+H for miniterm help.

To create a PTY for another serial tool instead, pass a name:

adbuart -n uart-console

This creates /tmp/uart-console and keeps the bridge running in the foreground. Open it from another terminal:

minicom -D /tmp/uart-console -b 2000000
# or
python3 -m serial.tools.miniterm /tmp/uart-console 2000000

Stop PTY mode with Ctrl-C in the bridge terminal. Clean shutdown in either mode restores RTOS logging when it was enabled before startup.

Options

Run:

adbuart --help
adbuart --version

Important options:

• Without --name, the command opens the UART directly in miniterm.
• -n, --name creates /tmp/<name> for use by another serial tool instead.
• -s, --serial selects an adb device. If omitted, exactly one device must be connected.
• --remote-tty selects the target UART device path. Default: /dev/ttyHS1.
• --baud sets the initial remote UART baud rate. Default: 2000000.
• --cmd-before runs a remote shell command before bridging. Repeatable.
• --cmd-after runs a remote shell command during teardown. Repeatable.

By default the tool sets persist.rtoslogd.uart to 0 before bridging so Android log collection releases the UART. During teardown it restores the property to 1 only when it was 1 at startup.

Operating notes

• The bridge owns the target UART exclusively while it is running. Stop it before flashing, resetting, or opening the same UART through another tool.
• In PTY mode, the local node is protected with a lock file, but unrelated tools can still collide at the device UART level.
• Avoid kill -9; it skips teardown and can leave RTOS logging disabled or, in PTY mode, a stale /tmp/<name> symlink.
• Serial disconnects during target reset are normal. Restart the bridge after the adb UART stream closes.

Development

python3 -m pip install -e '.[dev]'
pytest -q
python3 -m build

License

MIT