gerber-to-scad 0.1.8

Solder stencil generator, converts gerber files to a 3d-printable openSCAD solder stencil

gerber_to_scad

Simple python script for converting gerber files into a 3d printable solder stencil scad file

This repository has both a CLI tool, and a web app you can run locally or self-host. The tool used to run online at solder-stencil.me, but this is currently offline. If anyone misses it, let me know and I might bring it back!

Installation

• To install just the library: pip install gerber-to-scad
• To install the library and the web service: pip install "gerber-to-scad[service]"

gerber_to_scad requires python3.10 or higher.

Development setup

• Clone the repo
• Make sure you have poetry installed.
• Run poetry install.
• To activate the poetry virtualenv, run poetry shell.

Note: on M1 macs, scipy doesn't install correctly out of the box. If you're getting installation errors, try this:

brew install openblas
export OPENBLAS="$(brew --prefix openblas)"
poetry install

Usage

You'll get some information on available options if you run it with the -h argument:

(env) $ gerber_to_scad from-files --help

Usage: gerber_to_scad from-files [OPTIONS]

  Generate a stencil from an outline and paste gerber file.

Options:
  --outline FILE                  File containing the outline layer
                                  [required]
  --paste FILE                    File containing the solderpaste layer (top
                                  or bottom)  [required]
  --output FILE                   Output file  [required]
  -t, --thickness FLOAT           Stencil thickness in mm. Should be a
                                  multiple of your layer height.  [default:
                                  0.2]
  -n, --no-ledge                  Exclude the alignment ledge around the board
                                  outline.
  -f, --full-ledge                Include a full ledge (default is half
                                  ledge).
  -L, --ledge-thickness FLOAT     Ledge thickness in mm. Should be less than
                                  the PCB thickness.  [default: 1.2]
  -g, --gap FLOAT                 Gap in mm between board and ledge. Increase
                                  if fit is too tight.  [default: 0.0]
  -i, --increase-hole-size FLOAT  Increase all hole sizes by this amount in
                                  mm.  [default: 0.0]
  --flip                          Flip the stencil (use for bottom layer
                                  stencils).
  --openscad-binary PATH          Path to the OpenSCAD binary. Only used when
                                  output ends in .stl.  [default: openscad]
  --help                          Show this message and exit.

For basic usage, simply run the script with input files for the gerber outline and solderpaste files and specify an output:

gerber_to_scad from-files --outline=outline_file.gko --paste=toppaste_file.gtp --output=output.scad

Specifying a .stl file as the output file will directly call OpenSCAD to create the STL - if OpenSCAD is not on the path, you can use --openscad-binary=<path> to specify it

Contributing

Contributions are very welcome, I don't have a lot of time to spend on this project, but I try to review PRs as much as I can!

• Please use ruff to format your code - if you use VS code, you can open the gerber_to_scad.code-workspace file to get all the right automatic formatting in your editor, or you can just run ruff format . in the project root.