gif-color-changer 0.3.1

Replace colors across every frame of a GIF from the command line.

GIF Color Changer

Command line tool for replacing colors across every frame of a GIF.

Install

uv tool install gif-color-changer

From a local checkout:

uv tool install .

Usage

gifcc input.gif output.gif \
  --map "#FFFFFF=#FF0000" \
  --map "#000000=#00FF00"

Each --map is:

source_color=replacement_color

So this:

--map "#FFFFFF=#FF0000"

means:

replace white with red

You can pass as many mappings as you need. They run in order, and a pixel is only changed once.

Alpha is not part of color matching. The tool only changes RGB values and preserves each pixel's original alpha value, including fully transparent pixels.

Tolerance

GIF colors are often not exactly what they look like, especially after palette conversion or compression. Use --tolerance to match colors that are close to the source color.

gifcc input.gif output.gif \
  --map "#FFFFFF=#FF0000" \
  --tolerance 20

The default tolerance is 50.

Softness

Use --softness to blend pixels near the edge of the tolerance range instead of fully replacing every matched pixel.

gifcc input.gif output.gif \
  --map "#FFFFFF=#FF0000" \
  --tolerance 20 \
  --softness 8

With --tolerance 20 --softness 8, pixels within distance 12 of the source color are fully replaced. Pixels between 12 and 20 are blended proportionally from their original color toward the replacement color.

The default softness is 25. Use --softness 0 for hard replacement.

Palette Rewrite Mode

Palette mode rewrites every pixel by mapping its RGB value to the nearest color in a source palette, then forcing it to the color at the same position in a target palette. Alpha values are preserved unchanged.

gifcc input.gif output.gif \
  --source-palette "#000000,#808080,#FFFFFF" \
  --target-palette "#1D3557,#E63946,#F1FAEE"

Both palettes must contain the same number of colors. The source and target palettes are matched by position, so the first source color maps to the first target color, the second source color maps to the second target color, and so on.

Palette mode cannot be combined with --map, --tolerance, or --softness.

By default, palette mode uses squared RGB distance. Use --distance weighted-rgb to weight channel differences by perceptual luminance:

gifcc input.gif output.gif \
  --source-palette "#000000,#808080,#FFFFFF" \
  --target-palette "#1D3557,#E63946,#F1FAEE" \
  --distance weighted-rgb

Output

The script prints how many pixels were changed for each mapping:

(255, 255, 255) -> (255, 0, 0): changed 1234 pixel(s)

In palette mode, it prints how many pixels were assigned to each source palette bucket:

(0, 0, 0) -> (29, 53, 87): assigned 1234 pixel(s)

If a mapping says it changed 0 pixels, the source color probably does not exist in the GIF at that tolerance.

Uninstall

uv tool uninstall gif-color-changer

Development

Set up the repo:

uv sync

Run tests:

uv run pytest

Run tests against a specific Python version:

uv run --python 3.11 pytest

Or use the Makefile:

make test
make test-all
make test-3.11

Run the command without installing it as a tool:

uv run gifcc input.gif output.gif \
  --map "#FFFFFF=#FF0000"

You can also run the compatibility wrapper directly:

uv run python main.py input.gif output.gif \
  --map "#FFFFFF=#FF0000"

Build

uv build

That writes the package artifacts to dist/.