i2cx 0.9.3

Graphical interface for I2Cx Cyber Range, scanner-Lite(FT2232H),scanner (FPGA) and platform (stm32F7)

I²Cx Graphical User Interface

Code source is available on GitHub https://github.com/I2Cx-Cyber-Range/i2cx-gui

I²Cx Scanner Lite

Port A => can drive 4 mA (needed for SWD)

Port B => can drive 16 mA (useful to force logic level on bus like I2C and SPI and avoid reset master)

Install I²Cx Cyber Range graphical user interface

pip3 install i2cx

To start Graphical Interface of I²Cx Cyber Range

i2cx

I²Cx Cyber range can be used with OpenOCD (destination path need to adapted)

To use I²Cx Scanner Lite with openOCD you need to add a config file (available in tools folder)

wget https://github.com/I2Cx-Cyber-Range/i2cx-gui/tools/ftdi/conf_i2cx_scanner_-lite_lootus_pid.xml  -P /usr/local/share/openocd/scripts/interface/i2cx-scanner-lite.cfg

openocd -f interface/i2cx-scanner-lite.cfg -f target/stm32f7x.cfg  -c "adapter speed 4000;init;reset;" 

In another console

telnet 127.0.0.1 4444

To read firmware

flash read_bank 0 firmware.bin

On Ubuntu 20.04

Allow I2Cx Scanner Lite to non root user and Load FTDI driver to I2CX Scanner Lite

wget https://github.com/I2Cx-Cyber-Range/i2cx-gui/tools/openocd/i2cx-scanner-lite.cfg -P /etc/udev/rules.d/35-i2cx-cyber-range.rules

or add manually both line to a new file for example: /etc/udev/rules.d/35-i2cx-cyber-range.rules

SUBSYSTEM=="usb", ATTRS{idVendor}=="0403", ATTRS{idProduct}=="6E50", GROUP="plugdev"

ACTION=="add", ATTRS{idVendor}=="0403", ATTRS{idProduct}=="6e50", RUN+="/sbin/modprobe ftdi_sio" RUN+="/bin/sh -c 'echo 0403 6e50 > /sys/bus/usb-serial/drivers/ftdi_sio/new_id'"

In case of OpenGl issue

ImportError: libOpenGL.so.0: cannot open shared object file: No such file or directory

sudo apt update && sudo apt upgrade && sudo apt dist-upgrade && sudo apt-get install -y libopengl0

I2CX on windows

The probably easiest way to deal with libusb on Windows is to use Zadig

Start up the Zadig utility

Select Options/List All Devices, then select the FTDI devices you want to communicate with. Its names depends on your hardware, i.e. the name stored in the FTDI EEPROM.

With FTDI devices with multiple channels, such as FT2232 (2 channels) and FT4232 (4 channels), you must install the driver for the composite parent, not for the individual interfaces. If you install the driver for each interface, each interface will be presented as a unique FTDI device and you may have difficulties to select a specific FTDI device port once the installation is completed. To make the composite parents to appear in the device list, uncheck the Options/Ignore Hubs or Composite Parents menu item.

Be sure to select the parent device, i.e. the device name should not end with (Interface N), where N is the channel number.

for example Dual RS232-HS represents the composite parent, while Dual RS232-HS (Interface 0) represents a single channel of the FTDI device. Always select the former.

Select libusb-win32 (not WinUSB) in the driver list.

Click on Replace Driver