microlane 0.1.2

Self-contained RTL to GDS flow for simple chip designs

microlane

Self-contained RTL to GDS flow for simple chip designs

In a quest to better understand the chip hardening flow I challenged myself to write minimal implementations of Verilog parsing, synthesis, floorplanning, placement, routing and GDS streamout such that they can transform a simple RTL design into a layout that can be manufactured on Tiny Tapeout.

Of course, many corners were cut. 7000 lines of Python code written over a couple of weeks won't stand up to any serious EDA tool. But it does harden the demo design in a way that it passes DRC, LVS and the Tiny Tapeout precheck, as well as the gate-level cocotb testbench and the transistor-level SPICE simulation.

Limitations

• Supported PDKs: sky130A, gf180mcuD, ihp-sg13g2, ihp-sg13cmos5l.
• The floorplan is fixed to use a single 1x1 Tiny Tapeout tile.
• The design has to fit in a single Verilog module.
• There is only one clock domain. All synchronous logic has to use posedge clk.
• The gate level netlist is not optimised, so the area needed will be higher than usual.
• There is no static timing analysis. To prevent hold violations the design is modified to use a two phase non-overlapping clock generated internally. This ensures that it will work at some frequency but not at a particular one known in advance. Also, two physical clock ticks will correspond to one logical clock tick.
• There is no separate global and detailed placement, nor global and detailed routing. Performing them in a single step incurs extra runtime and memory use.
• There is no antenna check.
• The flow is in general rough around the edges. Features not covered by the demo design are only lightly tested and might break or raise "not implemented" errors. Changing the random seed can cause DRC violations in designs that worked previously.
• DRC, LVS, etc. are not part of the flow. You will need external tools for verification.

Usage

You can try hardening the demo design with:

pip install microlane
export PDK=sky130A
microlane demo.v

The command line interface writes outputs to the current directory and uses fixed settings. For more control, you can import the microlane library from a script and change the configuration.

References

These resources have been helpful in designing the microlane flow:

• VLSI CAD course by Rob A. Rutenbar
• Digital VLSI Design course by Adi Teman
• Slides for the VLSI Physical Design book by Andrew B. Kahng et al.
• Yosys internals documentation page
• TritonRoute article by Andrew B. Kahng et al.
• Tutorial series on writing a parser by CodePulse