phantom-hv 0.1.9

Control and monitoring utilities for the Phantom HV supply developed for SWGO at MPIK.

Phantom HV Control & Monitoring Software

This repository contains software to control and monitor a Phantom HV crate via Ethernet. The Phantom HV hardware is a modular 3-RU system that combines high-voltage supplies and high-frequency pulse pick-off circuits to operate photomultiplier tubes (PMTs). It has been designed for the SWGO and lab applications.

Software installation

You can find the newest packaged release of this library on PyPi. Untagged versions are released on TestPyPi as well.

Install via pip install phantom-hv.

Upgrade to the newest release with pip install -U phantom-hv.

Requirements

• Python 3 for the core library and command-line interface
• nicegui, pywebview, plotly and numpy for the Web UI (install via conda/mamba or pip)
  • note that pywebview (which is only needed for displaying the UI in a native application window) may require additional GUI framework components with Python extensions, especially on an otherwise headless server (e.g. by installing pywebview[qt], see the documentation)

Tools

If installed via pip this library provides two tools:

• phantomhv-ctl is a command-line interface to control and monitor a Phantom HV module
• phantomhv-webui provides a web interface with realtime plotting

phantomhv-ctl command-line tool

usage: phantomhv-ctl [-h] {boot,reset,flash,unlock-hv,lock-hv,enable-hv,disable-hv,set,monitor} ...

Low-level control and monitoring command-line tool for Phantom HV modules.

positional arguments:
  {boot,reset,flash,unlock-hv,lock-hv,enable-hv,disable-hv,set,monitor}
    boot                boot application slot
    reset               reset into bootloader
    flash               flash binary firmware image into application slot
    unlock-hv           enable HV
    lock-hv             disable HV
    enable-hv           enable HV channel
    disable-hv          disable HV channel
    set                 set hardware registers
    monitor             continuously read and print slave states

options:
  -h, --help            show this help message and exit

phantomhv-webui web interface

usage: phantomhv-webui [-h] [--address ip:port] [--num-slots {1,2,3,4,5,6,7,8}] [--show | --bind hostname:port]

Web UI to monitor and control a Phantom HV crate.

options:
  -h, --help            show this help message and exit
  --address ip:port     IP address or hostname of the device (default: 192.168.1.115:512)
  --num-slots {1,2,3,4,5,6,7,8}
                        number of modules to display (default: 1)
  --show                open UI in native window
  --bind hostname:port  bind web server to a specific network interface/port (default: 127.0.0.1:8080; use 0.0.0.0 to bind to all interfaces)