qolsys-controller 0.4.8

A Python module that emulates a virtual IQ Remote device, enabling full local control of a Qolsys IQ Panel

Qolsys Controller - qolsys-controller

A Python module that emulates a virtual IQ Remote device, enabling full local control of a Qolsys IQ Panel over MQTT — no cloud access required.

QolsysController

• ✅ Connects directly to the Qolsys Panel's local MQTT server as an IQ Remote
• 🔐 Pairs by only using Installer Code (same procedure as standard IQ Remote pairing)
• 🔢 Supports 4-digit user codes
• ⚠️ Uses a custom local usercode database — panel's internal user code verification process is not yet supported

✨ Functionality Highlights

Category	Feature	Status
Panel	Diagnostic Sensors	✅
	Panel Scenes	✅
	Weather Forecast	✅
	(Alarm.com Weather to Panel)
Partition	Arming Status	✅
	Alarm State	✅
	Home Instant Arming	✅
	Home Silent Disarming (Firmware 4.6.1)	✅
	Set Exit Sounds	✅
	Set Entry Delay	✅
	TTS	🛠️
Zones	Sensor Status	✅
	Tamper State	✅
	Battery Level	✅
	Temperature (supported PowerG device)	✅
	Light (supported PowerG device)	✅
	Average dBm	✅
	Latest dBm	✅
Z-Wave Devices	Battery Level	✅
	Node Status	✅
	Control Generic Devices	✅.
Z-Wave Dimmers		✅
Z-Wave Door Locks		✅
Z-Wave Thermostats		✅
Z-Wave Garage Doors		🛠️
Z-Wave Outlets		🛠️

⚠️ Certificate Warning

During pairing, the main panel issues only one signed client certificate per virtual IQ Remote. If any key files are lost or deleted, re-pairing may become impossible.

A new PKI, including a new private key, can be recreated under specific circumstances, though the precise conditions remain unknown at this time.

Important:
Immediately back up the following files from the pki/ directory after initial pairing:

• .key (private key)
• .cer (certificate)
• .csr (certificate signing request)
• .secure (signed client certificate)
• .qolsys (Qolsys Panel public certificate)

Store these files securely.

📦 Installation

git clone https://github.com/EHylands/QolsysController.git
cd qolsys_controller
pip3.12 install -r requirements.txt

# Change panel_ip and plugin_in in main.py file
python3.12 example.py