rawsock 0.0.2

a low level python implementation of a raw socket interface for sending Ethernet frames using Berkeley Packet Filters (BPF) on BSD based systems.

RawSocket

Overview

This repository contains a low level python implementation of a raw socket interface for sending Ethernet frames using Berkeley Packet Filters (BPF) on BSD based systems.

Prerequisites

Ensure you are running a Unix-based system (e.g., macOS, freeBSD, openBSD etc) that supports BPF devices (/dev/bpf*).

Installation

No additional dependencies are required. This module relies on Python's built-in os, struct, and fcntl modules.

Usage

Example Code

from rawsocket import RawSocket

# Create a RawSocket instance for network interface 'en0'
sock = RawSocket(b"en0")

# Construct an Ethernet frame with a broadcast destination MAC
frame = RawSocket.frame(
    b'\xff\xff\xff\xff\xff\xff',  # Destination MAC (broadcast)
    b'\x6e\x87\x88\x4d\x99\x5f',  # Source MAC
    ethertype=b"\x88\xB5",
    payload=b"test"  # Custom payload
)

# Send the frame
success = sock.send(frame)

# to send an ARP request:
success = sock.send_arp(
    source_mac="76:c9:1d:f1:27:04",
    source_ip="192.168.178.85",
    target_ip="192.168.178.22"
)

To receive incoming packets while sending:

sock = RawSocket("en0")
with sock.listener(5): # listen for 5 seconds
    success = sock.send_arp(
        source_mac="76:c9:1d:f1:27:04",
        source_ip="192.168.178.85",
        target_ip="192.168.178.22"
    )
print(sock.captured_packets)

Apply custom filters to capture specific packets:

# the following code listens for ARP packets with the specified
# dest mac address and checks if the target ip is available in payload
# which means the device has responded with its mac address if its
# connected to the network
with sock.listener(6, filter_ = {"ethertype": b"\x08\x06", "destination_mac": "76:c9:1d:f1:27:04", "payload": [b"\xc0\xa8\xb2\x16",]}):
    success = sock.send_arp(
        source_mac="76:c9:1d:f1:27:04",
        source_ip="192.168.178.85",
        target_ip="192.168.178.22"
    )
print(sock.captured_packets)

Methods

send(frame: bytes) -> int

Sends an Ethernet frame via the bound BPF device. Returns 1 on success, 0 on failure.

frame(dest_mac: bytes, source_mac: bytes, ethertype: bytes = b'\x88\xB5', payload: str | bytes) -> bytes

Constructs an Ethernet frame with the specified parameters.

send_arp(...)

A public method to send an ARP request.

Notes

• This code has been tested on macOS with python 3.13.
• The code assumes that at least one /dev/bpf* device is available and not busy.
• Packets may require root privileges to send. (on macOS you must run the script as root)
• Wireshark usually occupies the first found BPF device /dev/bpf0 if it's open and listening, so make sure to use /dev/bpf1 in the script.
• The system’s network interface must be in promiscuous mode to receive raw packets.

License

This code is licensed under the MIT License.