sj201-interface 0.1.0

SJ201 Interface

SJ-201 Interface

Contains Python bindings for released versions of the SJ201 using Mycroft testing code for reference.

CLI Usage

sj201 get-revision

Get a string representation of the detected SJ201 board (6 or 10) or 0

sj201 reset-led <color>

Chase the specified color and then chase off LED ring. Valid colors are:

• white
• yellow
• red
• green
• blue
• magenta
• burnt_orange
• mycroft_red
• mycroft_green
• mycroft_blue

NOTE: On the SJ201R10, this command must be run as root

sj201 set-fan-speed <percent>

Set the fan speed to the specified speed as a percentage.

NOTE: On the SJ201R10, changing the fan speed is currently not persistent and the fan will default to 100% after momentarily setting the requested speed. Setting speed to 0 will turn off the fan until the Raspberry Pi is shut down, at which point the fan will resume 100%.

sj201 init-ti-amp

Perform boot time initialization of the TAS5806 Audio Amplifier

sj201 patch-config-txt

Perform one-time update of config.txt for detected SJ201 hardware.

NOTE: Applying this could cause damage or unexpected behavior for connected HATs/GPIO components.

NOTE: reboot will cause kernel panics unless power is physically disconnected