xoople-cli

Command-line interface for the Xoople Products API, over xoople-sdk.

$ uv tool install xoople-cli
$ export XOOPLE_API_URL=https://api.xoople.com XOOPLE_TOKEN=...
$ xoople analyses list

Every command reads --api-url and --token from XOOPLE_API_URL and XOOPLE_TOKEN. --json prints the API response verbatim instead of a table, so output pipes into jq.

Commands

Signing in

auth login signs in through the browser with PKCE and stores the session at $XDG_CONFIG_HOME/xoople/session.json (~/.config/xoople/session.json by default), readable only by you. Every later command uses that session when no --token is given, and refreshes it when the access token is close to expiry.

$ export XOOPLE_API_URL=https://api.xoople.com
$ xoople auth login
$ xoople analyses list

auth login reads the CIAM client ID from the API. --ciam-client-id (XOOPLE_CIAM_CLIENT_ID) overrides it. auth status exits 3 when there is no stored session, so a script can test for a sign-in. --ciam-redirect-uri (XOOPLE_CIAM_REDIRECT_URI) overrides the loopback URI the browser returns to; it must match a URI registered for the CIAM client.

API keys

An API key lets a script or a CI job run the CLI without a browser sign-in. Create one on the API keys section of your Xoople profile page (/profile). The key starts with sk_ and is shown once, so store it in a secret manager.

A key belongs to one organization membership. It acts as you, in the organization that was active when you created it, with that membership's roles. To work in a different organization, create a key there.

Pass the key as the token. It takes precedence over a stored session:

$ export XOOPLE_API_URL=https://api.xoople.com XOOPLE_TOKEN=sk_...
$ xoople access me

The API accepts at most 300 API key requests a minute from one IP address. The CLI retries rate-limited GETs and replay-safe writes with backoff, then exits 8. Any other write exits 8 on the first 429, with no retry. Revoke a key on the same profile page when you no longer need it.

Submitting an analysis

The product spec is deeply nested and differs per product, so create and estimate take it as JSON rather than as flags:

$ xoople catalog designs --json | jq '.[0].spec_fragment' > spec.json
$ # fill in period and aoi, then:
$ xoople analyses create -f spec.json --display-name "South Wales NDVI" --wait

The file holds either the bare spec or a whole create request (anything with a spec key). -f - reads stdin. --wait polls the initial run and exits non-zero if it does not reach COMPLETE.

Exit codes

0 success · 1 unexpected CLI error · 2 usage error · 3 unauthenticated, including a failed or absent sign-in · 4 forbidden · 5 not found · 6 bad request or validation · 7 conflict · 8 rate limited · 9 server error · 10 connection failure · 11 unreadable response · 12 run finished in a non-COMPLETE state · 13 --wait timed out · 14 the analysis was deleted.