obniz-cli 0.0.5

cli tool for obnizOS setup

obniz_cli

obniz_cli is cli tool for obnizOS(for ESP32) install.

Installation

Using pip,

pip install obniz_cli

Preparation

Connect the ESP32 device from the serial port to your PC and check if the PC recognizes the device. The following command shows the list of devices.

python -m serial.tools.list_ports

(You can execute this command after pip install obniz_cli.)
In most cases, port name is dev/cu.SLAB_USBtoUART or like COM3. If you can't find these port or can find but fail to install, you may need USB-driver for devices from here.

Usage

flashos

obniz_cli flashos [-b] [-p]

You can install obnizOS to your ESP32 device. If you execute without -p option, it is displayed as follows:

0: /dev/cu.Bluetooth-Incoming-Port
1: /dev/cu.SLAB_USBtoUART

Select NUMBER from above list(or if you want to cancel, input N key):

Select the device you want to install. (A device port can be passed to command with -p option like obniz_cli flashos -p /dev/cu.SLAB_USBtoUART).

Then, latest obnizOS is downloaded and installed to device. By default, installation is performed at 115200bps but if installation failed, try to decrease it by obniz_cli flashos -b 115200.

After install, cli automatically change serial mode to set obnizOS configuration

eraseos

obniz_cli eraseos [-p]

You can reset your device by this command.